1. Á¦Ç°Á¤º¸ MeyerSound MINA 2. Á¦Ç°¼³¸í ¸ÞÀ̾î»ç¿îµå ÄÄÆÑÆ® ¶óÀξÀ̽ºÇÇÄ¿ MINA 1Á¶ 2ÅëÀÔ´Ï´Ù. ÇϿ콺 ¸ð´ÏÅÍ·Î »ç¿ëÇÑ ÀåºñÀÔ´Ï´Ù, °¢°¢ÀÇ ½ºÇÇÄ¿ ÄÁµð¼Ç ¾ÆÁÖ ÁÁ½À´Ï´Ù, °¢°¢ÀÇ ½ºÇÇÄ¿ ÀâÀ½¾øÀÌ Á¤»óÀÛµ¿ÇÕ´Ï´Ù, À½Áú¾ÆÁÖ ¸í·áÇÏ°í ´Ü´ÜÇÕ´Ï´Ù, Specifications:
Acoustical
Operating Frequency Range1: 66 Hz – 18 kHz
Frequency Response2: 70 Hz – 17.5 kHz ¡¾4 dB
Phase Response: 1 kHz – 18 kHz ¡¾30¡Æ
Maximum Peak SPL3: 128 dB
Dynamic Range: >110 dB
Coverage
Horizontal Coverage: 100¡Æ
Vertical Coverage: Varies, depending on array length and configuration
Crossover4
760 Hz
Transducers
Low Frequency:
Two 6.5" cone drivers with neodymium magnets
Nominal impedance: 4 ¥Ø
Voice coil size: 1.5"
High Frequency5:
3" compression driver
Nominal impedance: 8 ¥Ø
Voice coil size: 3"
Diaphragm size: 3"
Exit size: 1.2"
Audio Input
Type: Differential, electronically balanced
Maximum Common Mode Range: ¡¾15 V DC
Connectors: XLR female input with XLR male loop output
Input Impedance: 10 k¥Ø differential between pins 2 and 3
Wiring:
Pin 1: Chassis/earth through 220 k¥Ø, 1000 pF, 15 V clamp network to provide virtual ground lift at audio frequencies
Pin 2: Signal +
Pin 3: Signal –
Case: Earth ground and chassis
DC Blocking: Differential DC blocking up to the maximum common mode voltage
CMRR: >50 dB, typically 80 dB (50 Hz – 500 Hz)
RF Filter: Common mode: 425 kHz; Differential mode: 142 kHz
TIM Filter: Integral to signal processing (<80 kHz)
Nominal Input Sensitivity: 0 dBV (1.0 V rms, 1.4 V peak) continuous is typically the onset of limiting for noise and music
Input Level: Audio source must be capable of producing +20 dBV (10 V rms, 14 V peak) into 600 ¥Ø in order to produce maximum peak SPL over the operating bandwidth of the loudspeaker
Amplifier
Type: Three-channel, Class-D
Output Power6: 975 W (three channels; 2 x 375 W, 1 x 225 W)
Total Output7: 1950 W peak
THD, IM, TIM: <.02%
Load Capacity: 4 ¥Ø low channels; 8 ¥Ø high channel
Cooling: Convection
AC Power
Connector: PowerCon with loop output
Voltage Selection: Automatic, continuous from 90–265 V AC
Safety Agency Rated Operating Range: 100–240 V AC, 50/60 Hz
Turn-on and Turn-off Points:
90 V AC turn-on, no turn-off
Internal fuse-protection above 265 V AC
Idle Current: 0.256 A rms (115 V AC); 0.249 A rms (230 V AC); 0.284 A rms (100 V AC)
Maximum Long-Term Continuous Current (>10 sec): 1.26 A rms (115 V AC); 0.66 A rms (230 V AC); 1.50 A rms (100 V AC)
Burst Current (<1 sec)9: 3.24 A rms (115 V AC), 1.74 A rms (230 V AC), 4.02 A rms (100 V AC)
Ultimate Short-Term Peak Current Draw: 10.4 A peak (115 V AC), 5.2 A peak (230 V AC), 11.1 A peak (100 V AC)
Inrush Current: 7.1 A peak (115 V AC); 16.8 A peak (115 V AC), 20.0 A peak (230 V AC), 15.0 A peak (100 V AC)
RMS Network (optional)
Equipped with two-conductor twisted-pair network, reporting all operating parameters of amplifiers to system operator¡¯s host computer
Physical
Dimensions: 20.27" w x 8.38" h x 15.32" d with rigging pins (515 mm x 213 mm x 389 mm)
Weight: 41.2 lbs (18.69 kg)
Enclosure: Premium birch plywood
Finish: Black textured
Protective Grille: Powder-coated, hex-stamped steel with black mesh
Rigging: End frames with four captive GuideALinks, secured with 0.25" x 0.53" quick-release pins; metric M6 attachment
3. °Å·¡¹æ½Ä : Åùè/Á÷°Å·¡ (¹è¼Ûºñº°µµ) Ç°Àý 010-8888-7028 »ç¿îµå¸Ç °æ±â ÆÄÁÖ
»ó¼¼À̹ÌÁö ==>MeyerSound MINA ¸ÞÀ̾î»ç¿îµå ÄÄÆÑ.. : ³×À̹öºí·Î±× (naver.com)
|